My rinse cycle was not running because the cold water was not entering the washer

ApplianceGeneral Electric Washer

ModelWhdvh626fww

Level of DifficultyReally easy

Time to do repair15 - 30 mins

Age of Appliance5 - 10 years

Tools Pliers
Screw drivers
Wrench(Adjustable)

TERRESSA From TULSA, OK

May 31, 2013

I followed the instruction on your site. I disconnected the power to the washer turned off the water turned on the nearest faucets to drain the lines. I removed the water hoses from the machine then took the three screws out of the back at the top of machine that held the lid on then removed the three screws on the top of the lid that hold the plastic piece to the front panel and pushed the lid toward the back and it lifted off. I then took the metal ring clamp off the water line attached to the water inlet valve and took the screw out that is on the back of the machine holding it on removed the wire plugs one at a time and put them one at a time on the new inlet valve so I would not get them mixed up. I then put the valve in place reconnected the water hose and metal clamp put the screw in the back to reattach valve the machine put the lid back on in reverse to removal reattached water hoses to the inlet valve turned the water back on plug in the power and immediately used the machine which works like new 20 minute job from beginning to end. By the way ladies if I can do it you can do it. TC

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Water Inlet Valve

Part Number: PS1019151

$55.30
In Stock