Torn Door Boot Seal

ApplianceGeneral Electric Washer

Model

Level of DifficultyReally easy

Time to do repair1- 2 hours

Age of Appliance5 - 10 years

Tools Nutdriver
Screw drivers
Socket set

ROBERT From EDGEWATER, MD

May 24, 2013

Remove the bottom panel. Remove the top. Remove the front panel with the door. Romove the two clamps on the boot seal. Remove the old boot seal. Place the new boot seal on the casing around the drum and ensure you put the gasket nozzle and gasket nozzle washer in place. Install the inside gasket clamp with the clamp bolt to the right as you look at it (Note: ensure the nut is over the tab on the boot gasket and stays lined up there as you tighten it. Replace the front panel of the washer and when it is in place put the boot seal on the outside lip (Note: this is the most difficult part as the gaskets does not like to stay in place as you put the outside clamp on. Replace the washer top. Replace the lower panel (Note: while you have the bottom panel off, you may want to clean the debrie trap which is a white pipe and tray that catches stuff that is left in pockets.) For the entire project I used 7mm and 8 mm sockets, flathead screw driver, and a philips head screw drive.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

GASKET OUTSIDE CLAMP

Part Number: PS1016305

$9.82
In Stock

GASKET_NOZZLE_WASHER

Part Number: PS1016565

$2.49
In Stock

GASKET INSIDE CLAMP

Part Number: PS1019932

$11.48
In Stock

GASKET_NOZZLE

Part Number: PS1022231

$2.00
In Stock

Door Boot Seal

Part Number: PS1766023

$132.82
In Stock