Oven would not heat when turned on.

ApplianceMaytag Oven

Model

Level of DifficultyA Bit Difficult

Time to do repairMore than 2 hours

Age of Appliance1 - 4 years

Tools Screw drivers
Wrench set

Andrew From Hyrum, UT

Apr 06, 2013

out of people found this instruction helpful

Unplugged the oven from electricity. Took off the bottom(Floor) of the inside of the oven. Checked that the new part looked the same as the old. It did. Then I checked the back of the oven, had to take off a cover, and the connector in the back was not the same. I did not that it had the same two wires so rather than send it back, I figured I could make it work. I started to take off the old piece by unscrewing the two screws. They were a bit rusted, one came off the other I had to hacksaw and twist off. I cut the old connecting end off of the old part and the end off of the new part stripped the cover off the ends of the wires, and put the old end to the new part, having also put the old wire covers over the new wires. then twisted the end together and wrapped the in electrical tape. I had to take the piece that held the new part out of the oven the tried to use the one semi-good old screw, then some newer screws, then finally used some new nuts and bolts to connect the part tightly. put everything back together and it worked.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Gas Oven Igniter - Vertical Mount

Part Number: PS2085070

$55.77
In Stock