Rubber boot/seal was torn, causing front load washer to leak

ApplianceFrigidaire Washer


Level of DifficultyA Bit Difficult

Time to do repair1- 2 hours

Age of Appliance5 - 10 years

Tools Nutdriver
Screw drivers

mark From millbury, MA

Mar 24, 2013

lean washer back against wall, remove 2 screws from lower front panel.remove spring from front panel boot seal, pull seal loose from front panel, squeeze clamp and pull seal from detergent fill tube,remove spring from rear seal/ boot to drum, watch to see how it is attached to ease install of new one.lube new seal/boot rear section with dish soap. push seal on to drum working clockwise from top. it is difficult to get started, make sure arrow is pointing straight up at 12:00 oclock. replace spring around boot, start at one end and use spacers provided,have some one help with this. rest is simple. clip on detergent boot and use needle nose pliers to replace clamp, (a little difficult)crap type clamp. install seal to front panel and install spring. Done in about 1 hour. Directions were photo copy and dark and hard to see pictures.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Bellow with Clamp

Part Number: PS900237

In Stock