the brackets that support the front side of the tub were worn out and one of them was worn in two

ApplianceAmana Dryer

Model

Level of DifficultyReally easy

Time to do repair15 - 30 mins

Age of Appliance5 - 10 years

Tools Nutdriver
Screw drivers

Doug From Corning, AR

Feb 04, 2008

1 out of 2 people found this instruction helpful

I started at the bottom and removed the two nut screws that support the bottom section of the front of the dryer. Then I removed the two nut screws that supports the next section and disconnected the two wires ( making note of wich terminals each wire went to). Then I removed the lint trap housing( three phillips head screws hold it in place from the inside). Next ,I removed the face plate( held in place by 4 nut screws and two metal tabs at the bottom). Then I took the old tub brackets and felt seal off of the face plate . Next ,spray adheisive arond the ring of the face plate and install the new felt seal, then the new brackets and dryer glides and felt pads. Last, re-install all components.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

USE WPL 37001036 (Now subbed to Cylinder Glide Bracket)

Part Number: PS2039403

$18.07
In Stock

USE WPL 37001132 (Now subbed to Cylinder Felt Seal)

Part Number: PS2039485

$16.61
In Stock

USE WPL 37001298 (Now subbed to Drum Glide)

Part Number: PS2039613

$3.91
In Stock

Felt Pad (Now subbed to Single Felt Pad)

Part Number: PS2045752

$3.91
In Stock