Oven Would Not Start and F1 error code.

ApplianceJenn-Air Oven

ModelSVD48600W

Level of DifficultyReally easy

Time to do repair30 - 60 mins

Age of ApplianceMore than 10 years

Tools Nutdriver

Michael From Fuquay Varina, NC

Nov 28, 2012

1.)Unplug the oven from power. 2)remove two screwd securing sensor inside rear of oven. 3)pull oven away from wall/cabinet enough to access rear of the oven. 4) unplug sensor wire harness, and remove sensor from inside of oven. 5) Pass wiring harness of new sensor through inside rear of oven and secure with screws remove from original sensor. 6) connect wiring harnes at rear of oven (PartSelect sends two harness adaptors - sweeeet). Done = BONUS - you get to clean the floor under the oven. To replace the Bake/Broil/Convection Relay Board, remove the cover from the rear of the oven by removing the four sheetmetal screws- 1) Create a diagram of the relay board and depict the wiring colors connecting to the existing relay board (THIS IS A "MUST DO" TASK). 2) remove wiring from existing relay board by pulling connectors from the relay board. 3) Remove the relay board (there is wiring that may need to arranged to remove the board) 4) Mount new relay board. 5) Using the diagram created in step 1, connect the wiring to the new board 6) Attach cover on back of oven using care not to pinch wiring. 7) Push oven back into place. 8) Reconncet oven to power. DONE.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Long Oven Sensor

Part Number: PS1570174

$28.12
In Stock

Bake/Broil/Convection Relay Board

Part Number: PS2003250

$353.73
Recycling Rebate Available
In Stock