Would stop mid cycle.

ApplianceMaytag Dishwasher

Modelmbd9150

Level of DifficultyA Bit Difficult

Time to do repair1- 2 hours

Age of Appliance5 - 10 years

Tools Nutdriver
Screw drivers

Andrew From Elgin, IL

Nov 14, 2012

out of people found this instruction helpful

The dishwasher would hang up after about 10-15 min. on auto wash. You could hear the control board click but the pump wouldn't start. Ran the diag. process and it came up turbitity sensor. Found one on e-bay (no longer available from parts houses)put it in and had the same problem, this time the error was low motor voltage. Found, from others talking about the same problem on the net, that there were two other things to look for. One is where the wires go out the bottom of the door. The way the machine is designed after time the door will start to cut through them. Taped up any cut wires and made sure the connection was still good. Second, check the back of the control board for cold or loose solder joints. I found two for sure that were cold and the pigtail was also loose. Re-soldered the connections and ran a full cycle with no problems. The solder connections were most likely the problem to begin with. Hope this helps.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

O-RING

Part Number: PS2099344

No Longer Available