Water would not pump completely out

ApplianceMaytag Dryer

Modelmah4000AWQ

Level of DifficultyReally easy

Time to do repairLess than 15 mins

Age of ApplianceMore than 10 years

Tools Nutdriver
Screw drivers

Jason From Pleasant Hill, CA

Sep 22, 2012

Water would not pump out fully. Tried replacing the pump. That did not fix my problem. Bought a timer. Steps to replace (takes about 5 minutes). Unplug washer. Take out the 5 screws that are around the edge of the top panel. Do not take out the two screws that are in the middle of the panel. Those hold in other parts. The back tray will be seated and kind of flip down. Look for the part that looks like a timer. It is on the left hand side when looking at the back. Remove the one screw and slide the timer to the right. Remove the wire plug. Reverse the procedure to put in the new timer. Easy as cake. Crack open a beer and listen to the timer run through all the cycles.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Timer

Part Number: PS2020661

$124.20
In Stock