F1-8 code beeping keypad 6-0 inop

ApplianceJenn-Air Range

Model

Level of DifficultyEasy

Time to do repair30 - 60 mins

Age of Appliance1 - 4 years

Tools Nutdriver

JOHN From PALM BAY, FL

Jan 21, 2008

17 out of 25 people found this instruction helpful

Remove part from box and inspect. Place new part on bubble wrap. Notice only the ribbon cable and key pad come with new part.

Leave room to work.

Turn off circuit breaker and verify power is OFF.

Remove knobs and loosen the two screws for each switch.

Open oven door and place a rack at the highest level. Place a thick phone book on the rack and place a thick folded towel on top of it. This is to act as a protected table when removing and installing the new part.

Remove philips head screws from end covers and from angle bracket and stove. Leave screw nuts and angle bracket attached to old part for now.

Remove old part from stove by lifting up slightly then place on protected rack.

Slide lamp housing from red plastic lens and remove and store the red plastic lens for reuse.

Remove ribbon cable from circuit board. Remove fasheners from circuit board. Remove switches.

Remove old part and remove mounting bracket.

Re-install mounting bracket on new part and reinstall components in reverse order.

Verify that all connections are intact before mounting assembly to stove.

That's All Folks

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

USE WPL 74005747 (Now subbed to Control Panel with Touchpad)

Part Number: PS2083474

$247.34
In Stock