control board replacement

I removed the top cover, two bolts on the back (10mm) to expose the drum and back of the control board cover. Then pulled the detergent dispenser out. Removed the 4 screws holding the top front cover (one is in the front behind where the detergent dispenser closes). Lifted it and rolled it forward on the tabs to expose the control board. Removed the 5 screws holding the board in, disconnected the harness connections and removed the board. You will need to save the gray selector button and place on the new board before installing back into the cover. The new board has an additional part to install. It is a new motion sensor that the machine did not have originally and was explained in detail in the instructions on how to install and then test to verify it was working. Installation of the board was in reverse of removal with the only difference of plugging in the new motion sensor. Simple enough. Machine is now working better than new.