washer work not operate

ApplianceWhirlpool Washer

ModelLSQ9010PG2

Level of DifficultyEasy

Time to do repairLess than 15 mins

Age of Appliance5 - 10 years

Tools Nutdriver
Screw drivers

William From Ballwin, MO

Aug 28, 2012

out of people found this instruction helpful

Unplug washer from the electrical receptacle. Remove one phillip screw on each side from the rear of the control panel and one hexnut with plastic strap from the rear of the control panel on each side. Pull control panel towards the front of the washer. Locate gray lid switch on the top left, rear side. Remove metal grounding screw with green wire from the metal top of the washer. Detach the gray lid switch from the electrical module and remove entire switch. At this time, open the washer machine lid carefully and gently install the new lid switch. Reattach the ground wire and metal screw to the chassis. Put control panel back in it's original location, carefully align each of the rear side phillip screws and tighten. Do the same with the two hex nuts and plastic strap. Close lid and remember to plug the washer back in to the electrical receptacle. Start the washer with your normal procedure! It should now start!!! Good luck!

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Lid Switch

Part Number: PS886960

$21.75
In Stock