Level of DifficultyReally easy
Time to do repairLess than 15 mins
Age of Appliance5 - 10 years
Candance From hillsboro, OR
Aug 15, 2012
out of people found this instruction helpful
This was a simple repair. Removed the small access panel where the vent pipe comes through, the roller is right there. Unscrewed the support roller bolt, looking for all the pieces that had broken and fallen inside the housing of the dryer. Using the washers and nut from the old one, put the new roller in place, be aware that you have to lift the drum a little bit to get this new roller in. It could take two people depending on your strength. Tightened down the roller, spin the drum by hand to make sure it was ok, then put the access panel back on and fired it up for a test run.