Maker would not make ice

ApplianceFrigidaire Refrigerator

ModelPLHS239ZDB7

Level of DifficultyEasy

Time to do repair15 - 30 mins

Age of Appliance5 - 10 years

Tools Nutdriver
Socket set

Cecil From Blaine, WA

Aug 14, 2012

I suspected that the On/Off Switch was the problem. (Pressing and holding the switch 'on' for 15 seconds to recycle the icemaker did not bring the ice level control arm to life.) I decided to replace the whole icemaker rather than just the switch. (Do not try to replace the switch...almost impossible.) Steps: 1/Remove the Icecream shelf (lift up the front lip and pull out; 2/remove the Icecube holder tray (lift up the front and pull out.) 3/Remove the two hex head screws which are facing you above the ice maker. 4/Pull the icemaker slowly out and and down to reveal the electrical wiring, and unplug the electrical plug. 5/Follow new instructions re the water hopper and the ice-flapper-thingy on the new icemaker, and turn the new switch to 'off' before you start to install it. 6/Plug in the new icemaker, and push the electrical wiring down to the left as you push the icemaker into place, make sure the back edge of the water hopper goes under the water spout. 7/Replace and tighten the two hex head screws. 8/Press and hold the switch 'on' for 15 seconds or more to cycle the icemaker (the ice level control arm will slowly raise up and then go back down). 9/Replace the Tray and the Shelf. 10/Allow the icemaker time to cool and freeze the newly injected water.(This may take up to 6 hours.) 11/Listen for the sweet sound of the dropping icecubes.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Rear-Mount Ice Maker Assembly

Part Number: PS1992700

$90.07
In Stock