The dishwasher was not pumping out the water.

ApplianceMaytag Dishwasher

Model

Level of DifficultyEasy

Time to do repair15 - 30 mins

Age of Appliance1 - 4 years

Tools Wrench set
Wrench(Adjustable)

Severo From Houston, TX

Jan 17, 2008

1 out of 2 people found this instruction helpful

First I shut off the water and electricity to the dishwasher. I removed the screws holding it in the cabinet and pulled the dishwasher out. Disconnect the water line and turn the unit face down on the floor. I disconnected the wire harness by pulling it out. It was a little hard to pull out. Then I removed the screws holding the pump in place, then removed the pump. I inserted the new pump and replaced the screws, and the wire harness. Then stand the unit upright, reconnect the water line (use teflon tape to prevent water leakage), put the dishwasher back in the cabinet, and restore power and water. Then you're done. It would have been very simple if I had used teflon tape the first time. I had a leak the first time I reconnected the unit and had to take it out again and apply the teflon tape. After that, everything was fine. The dishwasher works great.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

USE WPL 6-917641 (Now subbed to Drain Pump)

Part Number: PS2340929

$55.04
In Stock