Loud Knocking during the Spin Cycle

ApplianceMaytag Washer

ModelMAH3000AWW

Level of DifficultyVery Difficult

Time to do repairMore than 2 hours

Age of Appliance5 - 10 years

Tools Wrench set
Pliers
Nutdriver
Screw drivers
Socket set
Wrench(Adjustable)

Bradley From Round Rock, TX

Jan 16, 2008

34 out of 45 people found this instruction helpful

Removed the Rear and Front Skins of the Washer. Removed the Belt and Tub Drive Wheel from the rear of the Tub. Removed the Front Rubber Gasket and Bracket Assy. Removed the Tub Cover w/Seal, Spinner Balance Ring (both were damaged.) Knocked the Spin Tub forward with a sharp hammer-rap on the Axle (the Axle is pressed into a Bearing that remains in the Stationery Tub.) Removed the Spinner Assy--found one of the securing bolts on the tri-Arm Support sheared off causing an imbalance. Also, the tri-Arm Support was cracked in various places. Replaced all bad parts using the Spinner Support Assy Kit and new Plastic Washers. Replaced everything else in reverse order then tested. Finally, reinstalled all Machine Skins. Very successful, about 3 hours.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

USE WPL W10181639 (Now subbed to Spinner Support and Seal Kit)

Part Number: PS1964673

$108.60
In Stock

USE WPL 22002023 (Now subbed to Plastic Washer)

Part Number: PS2019984

$3.82
In Stock

USE WPL 22003212 (Now subbed to Tub Cover with Seal)

Part Number: PS2020850

$73.84
In Stock

USE WPL 6-2717080 (Now subbed to SPINNER AS)

Part Number: PS2347251

$358.75
In Stock