BOX SIDE HOT FREZER WORKING FINE

ApplianceMaytag Refrigerator

ModelRSW2200EAE

Level of DifficultyEasy

Time to do repair1- 2 hours

Age of ApplianceMore than 10 years

Tools Nutdriver
Screw drivers

James From Mc Alester, OK

Jul 28, 2012

PULL BOX OUT ""UNPLUG BOX"" EMPTY FREZER INCLUDING STORAGE BASKETS,PLACE ICE MAKER IN OFF REMOVE ICE CUBE BOX, DO NOT REMOVE ICE MAKER, USEING NUT DRIVER LOOSEN SIDE RAIL SCREWS ABOUT 1/4"SLIDE BASKET RAILS IN OR OUT AND PULL TO CENTER OF BOX SHOULD SLIP OFF SCREWS, REMOVE LIGHT BULB COVER & BULB, REMOVE 4 SCREWS HOLDING ICE WORM DRIVE MOTOR "" HOLD "" WILL FALL IT IS ATACHED TO A ELECTRIAL PLUG UN PLUG AND LAY ASIDE,UNSCREW BACK PANLE SCREWS 4 LEFT 4 RIGHT ON BACK COVER, " REMOVE HIDEN SCREW AT TOP CENTER OF BACK PANEL AND PULL UP AND PRY OUT AT BOTTOM SILDE OUT DOWNWERDS,REMOVE CROSS PLATES ONE CENTER ONE BOTTOM THESE HOLD DEFOSTER BARS, UNWIND WIRES CENTER DEFROSTER BAR SOMEWHAT DIFECULT BOTTOM ONE JUST SLIDE DOWN UNPLUG FROM PANEL AT TOP BEHIND WHERE ICE CUBE DRIVE WAS LOCATED, REPLACE NEW DEFROSTER ASSM REASEMBLE DEFROSTER BARS INTO CROSS BARS WIND IN & PLUG UP NEW WIRES BEHIND COOLING FINS BEING CAREFULE NOT TO CUT OR NICK WIRES OF BEND COOLING FINS REPLACE SCREWS,WIRES ARE 1 SMALL PLUG 1 LARGE,REINSTALL BACK PANLE TOP CENTER SCREW FIRST DON'T TIGHTEN ALINE SIDE SCREW HOLES REPLACE SIDE SCREWS THEN TIGHTEN TOP SCREW.REPLACE DRIVE MOTOR BEING SURE TO CONECT,REPLACE BULB,BULB COVER,SIDE RAILES,BENS,ICE CUBE BOX & PUT ICE MAKER LEVER IN ON POSS.PLUG BOX IN WEIGHT 8 TO 10 HOURS WITH BOX SET AT MFG 'S STARTING SETTINGS. SHOULD WORK LIKE A CHARM.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Defrost Heater

Part Number: PS2057764

$27.92
In Stock