Hot water did not flow when requested

ApplianceWhirlpool Washer

Modeltaws800jQ1

Level of DifficultyEasy

Time to do repair15 - 30 mins

Age of ApplianceMore than 10 years

Tools Nutdriver
Pliers
Screw drivers

Gregg From Troy, NY

Jul 24, 2012

After shutting of water and removing supply hoses I started out removing the two small sheet metal screws on rear top and side top to remove dash board. Removed two large spring clips that hold the top and back together that are hidden by dash. pulled back panel back to access valve from left (looking at back of washer) Removed sheet metal screw securing valve plate to back panel. Moved hose spring clamp below hose barb on valve. Disconnected hot and cold switch plugs from valve and installed new valve using reverse steps above. Vacuumed and wiped down dust and lint from washer and put back in place. I used a short stool to ease working at a low position.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Water Inlet Valve with Mounting Bracket

Part Number: PS334646

$17.08
In Stock

Bleach Dispenser - White

Part Number: PS342396

$3.27
In Stock