Dryer would squeal when first starting and then gradually became very noisey.

ApplianceGeneral Electric Dryer

ModelDSPR473EW0WW

Level of DifficultyA Bit Difficult

Time to do repairMore than 2 hours

Age of Appliance5 - 10 years

Tools Screw drivers

Gene From Kutztown, PA

Jan 15, 2008

8 out of 10 people found this instruction helpful

The repair was done as follows:

1. Removed the door
2. Removed the two screws securing the top panel then removed the panel.
3. Removed the two screws securing the front panel then removed the panel.
4. Removed the screws securing the left side panel then removed side panel and the two leveling feet.
5. Tipped dryer over on its back (you will want to protect your floor, the four screws that attach the heater unit protrude through the back).
6. Disengaged the belt tensioner and removed the belt and the drum.
7. Removed the three Torx screws securing the drum bearing to the drum and discarded old bearing.
8. Removed the four screws securing the bearing retainer to the heater unit.
9. Removed the four screws securing the heater unit and two sensor wires.
10. Lifted heater unit just high enough to remove bearing retainer. Discarded bearing retainer.

The new drum bearing kit is supplied with self tapping screws. I installed the screws into the bearing parts to tap the holes and then removed them prior to assembly.

11. Installed new bearing retainer to back of heater unit using the supplied screws. Install the four screws by hand, finger tight.
12. Re-attached heater unit and tighten screws.
13. Re-attached sensor wires.
14. Tightened the four bearing retainer screws.
15. Attached new drum bearing to drum using the three supplied Torx screws. I used tape to hold everything together while installing the screws.
Tightened the Torxscrews.

Next I used a vacuum to remove all the lint from inside the dryer. I also used a small plastic putty knife to remove the caked on lint on the impeller blades.

16. Inserted drum bearing into bearing retainer.
17. Installed drum belt and belt tensioner.
18. Installed left side panel and feet.
19. Replaced the two grey and two white slide bearings on the front panel. They just slip onto a small post and slide into a slot.
20. Installed front panel. (Rotate drum to help with installation)
21. Installed top panel and door

PROBLEM SOLVED!

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Rear Drum Bearing Kit

Part Number: PS267529

$46.29
In Stock

Front Dryer Drum Slide (Now subbed to Drum Bearing Slide - White)

Part Number: PS755842

$6.14
In Stock

Light Bulb - 120V 10W

Part Number: PS960329

$3.79
In Stock

BELT DRIVE (Now subbed to Drive Belt)

Part Number: PS1766009

$19.98
In Stock

Dryer Drum Slide (Now subbed to Drum Bearing Slide)

Part Number: PS6447706

$3.86
In Stock