Dishwsher would not fill with water

ApplianceMaytag Dishwasher

ModelMDB7600Aww

Level of DifficultyEasy

Time to do repair1- 2 hours

Age of Appliance5 - 10 years

Tools Nutdriver
Pliers
Screw drivers
Wrench set
Wrench(Adjustable)

Mike From Hacienda Heights, CA

Jun 28, 2012

After turning off the power and the water supply, I removed the old valve and replaced it with the new valve. Very simple -- the inlet line to the valve is attached with a hex fitting. The outlet is attached with a spring clamp. There is an electrical connector which powers the solenoid that opens the valve. The connector simply pulls off the old valve and is pushed back onto the new valve. With the power still off, I turned on the water supply to check for leaks. There were no leaks, but to my surprise, water immediately surged through the valve and into the dishwasher! -- Remember, there was no power to operate the solenoid! BAD VALVE? Back to the Internet. So far, I've found no other explanation. HELP!!

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Water Inlet Valve

Part Number: PS2099976

$54.73
In Stock

Float Switch Kit

Part Number: PS2344786

$40.70
In Stock