Low flow of cold water into tub

ApplianceWhirlpool Washer

ModelLST7233DQO

Level of DifficultyReally easy

Time to do repair15 - 30 mins

Age of ApplianceMore than 10 years

Tools Nutdriver
Screw drivers
Wrench set

Dan From Virginia Beach, VA

May 20, 2012

Unplugged washer. Shut off hot and cold water. Pulled the washer away from the wall slightly to remove the hoses. Once disconnected I pulled the washer out further. Removed the two screws holding faceplate. Then popped the two tabs, allowing the tub cover to be removed. Disconnected the wire connector from the pins, and then removed the tub cover. I was then able to disconnect the water inlet valve. I replaced the water inlet valve, the internal hose and the two clamps. Then did the above in reverse order.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Water Inlet Valve with Mounting Bracket

Part Number: PS334646

$17.97
In Stock

Water Inlet Hose

Part Number: PS341606

$9.65
In Stock

Hose Clamp

Part Number: PS380193

$2.70
In Stock