Could not select Ice or Water, switch would not connect

ApplianceGeneral Electric Refrigerator

Modeltps24bpcbs

Level of DifficultyEasy

Time to do repairLess than 15 mins

Age of Appliance5 - 10 years

Tools Screw drivers

Steve From Gastonia, NC

May 16, 2012

out of people found this instruction helpful

Pop off the Plastic cover over the Ice maker panel in the door.Remove the 4 Phillips screws. Pop off the rubber Switch pad in the back. Open the Freezer door to disconnect the power and stop water flow. Pull the assembly forward watching the water spout pull through the gap in the lever. Disconnect the white connector by gently pulling it up, it assembles only 1 way. Pull the 2 switch knobs off. With the assembly loose. there are 2 Phillips screws that need to be removed. The cover comes up, and the pc control board slides out. Insert the new control board and reverse the procedure. Be a little careful when inserting the assembly so that the water spout comes through the gap in the lever.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Dispenser Control Board - 2 Slide Switches

Part Number: PS304236

$73.67
In Stock