Water would not drain, motor died

ApplianceWhirlpool Washer

Modelwfw9200s

Level of DifficultyA Bit Difficult

Time to do repair15 - 30 mins

Age of ApplianceMore than 10 years

Tools

Michael From Worcester, MA

Jan 10, 2008

16 out of 20 people found this instruction helpful

Remove the lower front cover there are three small torx type screw. The pump is the very first thing you see. Have a wet and dry Vac available you will need it. The drain pump and the drain lines contain a lot of water. Unscrew the big white drain plug at the pump and clean up the water, remove the front small mounting screw and disconnect the two hoses in the back of the pump with pliers and follow the pre-printed steps in reverse. If your machine is more than six years old you will have to use a utility knife and remove a piece of plastic on the electrical connector that is from the washer wiring, if you force the connection on it will brake, look at the connection and the plug and attempt to plug it in before you install the pump. It is easy just be-aware of the connector.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Drain Pump Kit

Part Number: PS1485610

$148.21
In Stock