The door latch mechanism was broken, thus preventing the diswasher from operating and sealing properly

ApplianceMaytag Dishwasher

ModelMDB9150AWQ

Level of DifficultyA Bit Difficult

Time to do repair30 - 60 mins

Age of Appliance5 - 10 years

Tools Nutdriver
Socket set

Thomas From INDIALANTIC, FL

Feb 04, 2012

1 out of 3 people found this instruction helpful

First, shut off power to the dishwasher. Remove the stainless outer panel from the door to expose the latching mechanism and control board. Remove the latch mechanism from the inner door panel (if plastic pin holders are still intact) and place off to side. No need to disconnect wires. Remove the control panel by taking out hex head screws and snapping out of retainers on old control panel. Again, no need to disconnect wires; let the board hang out of the way. Remove old control panel by removing hex head screws. Replace with new control panel. Snap control board back into place and secure with hex head screws. Be sure it is seated properly. In my case the door latch handle was also broken. Simply snap new one back into latch mechanism. Replace outer stainless door panel with torx screws and you are done.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Door Latch Handle

Part Number: PS2100169

$30.95
In Stock

Control Panel

Part Number: PS2340886

No Longer Available