Attachments would not work, spindle turned erratically, with no power

ApplianceKitchenAid Small Appliance

ModelKSM90GN

Level of DifficultyEasy

Time to do repair30 - 60 mins

Age of ApplianceMore than 10 years

Tools Screw drivers

Kerry From Sherwood, OR

Jan 25, 2012

2 out of 4 people found this instruction helpful

Punched out the roll pin to remove eccentric from spindle, undid 5 screws (after removing trim ring), and removed 4 screws to undo the motor housing. Make sure to keep the one screw with a lock washer in the BACK of the housing. Undid the screw on top to remove the back of the motor housing to take out the strain relief grommet, prior to removing the motor housing. Scraped the excess grease into a tub to re-use. Pulled out the shaft, and lifted out the old (stripped) gear and plopped the new one in. Make sure to mark match points for parts, and put the pins back in in the right order. You have to put the 5 screws back in before sliding the trim ring on, and putting the roll pin back. make sure all gears mesh and test before snugging the motor housing screws. Be sure to orient the strain relief grommet securely, and be careful of the filter plates in the back of the housing (they're brittle). putting the grease back is like frosting a cake. Save a little for the planetary ass'y.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Bevel Pinion Center Gear

Part Number: PS989663

$11.04
In Stock