Original timer would not advance through cycles.

ApplianceKenmore Washer

Model110.82283830

Level of DifficultyEasy

Time to do repair1- 2 hours

Age of ApplianceMore than 10 years

Tools Nutdriver
Screw drivers

Joyce From Cape Coral, FL

Jan 25, 2012

0 out of 1 people found this instruction helpful

The repair was easy to do. I removed the back panel from the control console of my Kenmore washer. Taking out the old timer was just a matter of removing two screws and the control knob from the front of the panel. Then I unplugged a connector block and disconnected one other wire by pulling it out of a wire nut which it was designed to do. When I proceeded to install the new timer, I discovered that the two screws from the front of the panel were slightly larger than the threaded holes in the new timer. I went to Home Depot and bought a size 10/32 tapping drill bit which I used to enlarge the threaded screw holes in the new timer. It was very simple to do. This added more time to the installation. Had I not encountered this problem, I could have installed the new timer in less than an hour, but at the same time, I learned how to solve the problem. The new timer works fine.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

TIMER

Part Number: PS349304

$144.88
In Stock