stove top burner not heating

ApplianceGeneral Electric Range


Level of DifficultyReally easy

Time to do repairLess than 15 mins

Age of Appliance5 - 10 years

Tools Nutdriver

Jon From Readsboro, VT

Jan 25, 2012

1 out of 2 people found this instruction helpful

The longest part of the job was finding my misplaced nut driver!!Note:A small socket set will do.Unplug stove from outlet,remove rear cover panel,lift stove top up to access terminal. remove the one screw that holds the terminal and slide off the two wire clips that hold the wires up out of the clip off the old terminal leaving the old wires so you can tape the new wires on just to pull them through the hole.Once you have the new wires pulled up to the heat control unplug old and replace with the new,tighten the screw on the new terminal and don't forget to slide on the wire clips

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Surface Burner Terminal Block Kit

Part Number: PS242972

In Stock