Load Squeaky noise when the dryer is tumbling

ApplianceMaytag Dryer

Model

Level of DifficultyReally easy

Time to do repair30 - 60 mins

Age of Appliance1 - 4 years

Tools Nutdriver

Antonio From Elk River, MN

Dec 20, 2007

36 out of 39 people found this instruction helpful

To make working on the dryer easier we tipped the dryer back, about 45 degrees, removed the bottom panel, the door panel, note: make sure to mark the inside chassis or case with a sharpie where the wires go by color, etc… note: this makes it easy to place every thing back in order. I removed three screws on the bottom left side, to allow the more room for me to remove the drum. You can not remove the drum just yet but until the rubber belt is removed. I went below where the tension wheel is… it’s back behind the motor… incidental the tension wheel and the arm was the problem, it had warn to one side. Now release the rubber belt around drum. I pulled the drum out. The motor assembly is all one piece so it’s easy to remove. Don’t forget to unplug the plastic Molex plug and mark where you wires go. Two screws in front on the motor assemble and the whole assemble comes out. From here I could do a good job of cleaning the motor assemble and replacing the parts without any difficulty. Re-assembly was really easy, just one issue with placing the rubber belt took some time, and I need some help. I was finished in less than two hours. Bingo fixed!!

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

USE WPL 37001144 (Now subbed to Idler Pulley Lever and Shaft)

Part Number: PS2039496

$14.16
In Stock

Idler Pulley Wheel (Now subbed to Idler Pulley Wheel with Bearing)

Part Number: PS2200898

$4.06
In Stock