Washer drum not spinning correctly

ApplianceMaytag Washer

Model

Level of DifficultyA Bit Difficult

Time to do repair1- 2 hours

Age of ApplianceMore than 10 years

Tools Wrench set
Pliers
Screw drivers
Socket set

Paul From Huntley, IL

Dec 20, 2007

14 out of 15 people found this instruction helpful

Drum on the Maytag washer was not spinning is a true rotational pattern. Adjust or replace the centering springs.

How-to-description
I had to hack saw off the centering springs eye bolts since they were rusty and not adjustable. If you have to cut the old eye bolts as I had to, be careful... the spring will jump up an inch or two very quickly and you want to keep your hands clear. It makes a load noise and my wife asked "what happened". Not a big deal, just be aware of the spring returning to a normal state.
Place the new eye bolts in position and tighten the nut with 4 turns. With duck tape I held the eye bolts in place from under the machine. Had my son push the drum towards the replaced spring to shorten the length of the end of the spring to the eye bolt. Stretch the new springs with a long screw driver, one end against the washer body, and the other end near the handle. Pulled down on the scrw driver until the spring can hook onto the eye bolt. Before cutting the old eye bolts I measured the length of the eye bolt from the spring to the frame. Adjust the new eye bolts to the same length after the spring is stretch onto the eye bolt. Overall a simple project, cost $40 for me and the best advice is using the long screw driver to pull down on the springs.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Eyebolt Nut (Now subbed to Eyebolt Nut)

Part Number: PS2018613

$3.83
In Stock

USE WPL 216416 (Now subbed to Centering Spring Eye Bolt)

Part Number: PS2019186

$3.83
In Stock

Centering Spring (Now subbed to Centering Spring)

Part Number: PS2019505

$3.91
In Stock