the glow ignitor would not cycle on

ApplianceMaytag Dryer

Modelldg7334aae

Level of DifficultyEasy

Time to do repairLess than 15 mins

Age of ApplianceMore than 10 years

Tools Pliers
Nutdriver

Georgio From Oradell, NJ

Nov 15, 2011

4 out of 5 people found this instruction helpful

I had an issue where I was not getting any power to my ignitor. After replacing the ignitor with a fresh one, the problem persisted. Next, I went hunting all the fuses and therrmostats for continuity. All seemed fine. So finally I decided to jump the flame sensor which is located on the outside of the flame tube. WHALLA! It ignited the glow plug. So with one 1/4"" nut driver I removed the single bolt from the unit, then I used a pliers to remove the two wires from the old unit. I replaced the sensor with Tue new unit and all was well. It took less than 5 min once I diagnosed the problem.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Radiant Flame Sensor

Part Number: PS344761

$25.16
In Stock