Dishwasher would not do anything

ApplianceMaytag Dishwasher

Model

Level of DifficultyReally easy

Time to do repair15 - 30 mins

Age of Appliance1 - 4 years

Tools Nutdriver
Screw drivers

Robert From Olathe, KS

Dec 11, 2007

24 out of 29 people found this instruction helpful

1. Turned off power at breaker. 2. Removed the six screws holding the interior panel to front panel. 3. Disconnected the power cables from the soap door and the handle release. 4. Removed the 3 screws holding the computer control board. 5. Removed the wire bundles from the board...only one way to take them off and put them back on...very easy. 6. Found two clips holding the board in place and removed the computer control board. 7. Replaced with new board into clips...and re attached the wire bundles. 8. replacing the panel control was a snap with 2 screws and the wires fit onto the control board easily. 9. Replaced the interior panel and attached the wires back to the handle release and the soap dispensor. 10. Replaced the screws for the panel. 11. Reset breaker 12. Wahlah....ran the dishwasher like it was new.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

USE WPL 6-919840 (Now subbed to PANEL- CON)

Part Number: PS2341105

$155.16
In Stock

USE WPL W10218822 (Now subbed to Electronic Control Board)

Part Number: PS2352372

$152.87
In Stock