loud squeaking when loaded

ApplianceMaytag Dryer

ModelLE410?

Level of DifficultyEasy

Time to do repair1- 2 hours

Age of ApplianceMore than 10 years

Tools Nutdriver
Screw drivers

Jeff From North Prairie, WI

Dec 08, 2007

5 out of 5 people found this instruction helpful

Followed advice from here; unplugged machine from power source, removed two phillips head screws located just out of sight below the little indentaion on the front panel, removed front panel & set aside the machine. Unclipping the door switch wires allowed for enough slack so that they didn't need to be disconnected. Unscrewed (or un-hooked, don't remember) the lint box, pulled the drum out slightly, removed the belt, pulled drum out all the way & set aside. Removed the snap rings & wahsers from the idler wheels, removed wheels, put a light coating ot synthetic grease on the shafts & in the idler bushings, re-installed idlers, washers, & snap rings. Re-assembled in reverse order of assembly with alittle difficulty iin getting the new belt in the proper configuration. Removed small access panel in rear of machine to assist in installng the belt finally realizing that the belt DOES NOT go in the indented area of the drum, but on the larger diameter of the drum itself. Tested by rotating by hand, re-assembled front cover, plugged it in & dried the laundry......QUIETLY!

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Multi Rib Belt - 100" (Now subbed to Tumbler and Motor Belt)

Part Number: PS2200550

$14.01
In Stock

USE WPL 6-3051850 (Now subbed to Motor Pulley - No Set Screw)

Part Number: PS2347257

$32.11
In Stock