There was a slight amount of water (6 - 8 oz.) on the floor after every wash

ApplianceRoper Washer

Model

Level of DifficultyEasy

Time to do repair15 - 30 mins

Age of Appliance5 - 10 years

Tools Pliers
Screw drivers

Duane From Macon, GA

Jun 06, 2011

0 out of 1 people found this instruction helpful

I disconnected the power supply then proceeded to tilt the washer top toward the back and propped the washing machine up about 1' off the floor. Once the machine was stablized I proceeded to remove two clamps to the pump using a pair of pliers and allowed any water inside to drain. Then I proceeded to unsnap the top and bottom pieces of metal holding the pump in place with a large slotted screw driver. Once the metal holds were removed I was easily able to pull the water pump toward the front of the washing machine. Then I installed the new pump and snapped the two metal bands down upon the pump to hold it in place. I then proceeded to hook up both hoses to the pump and using a pair of pliers clamped the hoses securely in place. I then placed the machine back on the ground, plugged in the power supply and ran a test cycle to make sure it worked and that there were no leaks.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Direct Drive Water Pump

Part Number: PS342434

$29.85
In Stock