Loud banging sound. Worn out roller.

ApplianceSpeed Queen Dryer

ModelAGM499W2

Level of DifficultyReally easy

Time to do repair15 - 30 mins

Age of ApplianceMore than 10 years

Tools Socket set

David From Underwood, IA

Apr 05, 2011

101 out of 164 people found this instruction helpful

Pulled off the lower panel with 5/16 socket.Pulled off the door assembly by removing the two screws at the bottom of the door assembly. I pulled down a little and then out. be carefull of the wires. Other posts said to remove. The wires were long enough I did not have to remove them. I just leaned it against the wall. I then removed the 4 screws that hold the front piece in.pulled it off replaced brackets , installed self adhesive felt(stuck good) and then glides. Mine were thin but not the problem. I then reached under the drum and released the belt from the tensioner. I then pulled the whole drum out.This is the time to vacum out good. I could get to the rear rollers very easy. The left roller was shot and the shaft half wore into(the problem). I pulled off the two screws holding the roller support. Normally You have to remove the wheel with snap ring pliers first to remove the support. In this case snap ring long gone. Replaced support shaft, installed thrust washers and roller with grease for both sides. The right support shaft was still good. Removed tensioner pulley and inspected. It was just as good as the new one. Cleaned and greased and reinstalled. Put new belt on the tub and slid it back in. Be carefull to get the belt on the proper side of the tensioner. I then installed the front supprt in place to support the tub with the 4 screws. Spun the tub(felt good) then reached under and reinstalled belt to motor and tensioner. Spun again to check for belt alignment. (Check) Reinstalled door an lower panel. Test Quiet Sounds like new. Very easy! I hope this helps someone just as the other post has helped me. Blessings to all.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Thrust Washer

Part Number: PS333174

$4.46
In Stock

Single Drum Glide Felt Pad

Part Number: PS1610155

$3.91
In Stock

Glide Bracket Kit

Part Number: PS2003560

$39.21
In Stock

Retaining Ring

Part Number: PS2025108

$2.70
In Stock

Drum Support Roller

Part Number: PS2039408

$7.64
In Stock

Drum Glide

Part Number: PS2039613

$4.41
In Stock

Multi-Rib Belt

Part Number: PS2041323

$13.80
In Stock

Roller Bracket and Shaft Assembly

Part Number: PS2041342

$19.23
In Stock

Idler Pulley Wheel with Bearing

Part Number: PS2200898

$4.80
In Stock