broken belt and the pump was damaged/stripped

ApplianceMaytag Washer

Modelbeltandpump

Level of DifficultyA Bit Difficult

Time to do repair30 - 60 mins

Age of Appliance1 - 4 years

Tools Pliers
Nutdriver
Screw drivers

Anh From San Jose, CA

Nov 24, 2007

6 out of 8 people found this instruction helpful

To replace the pump and belt for the Maytag washer, you really need remove the springs and suspended the tubs. I needed help to pull the 2 springs out (high tension) with a big plier. I removed the 3 bolts that held the motor to the frame and flipped it out to the side to expose the 3 long screws that attached the pump to the motor. The pump was easily removed and replaced with the Philip screw driver. I preset the belt between the pump and the rotor before sliding the motor back in place. After botling the motor back into the frame and carefully pull and snap the spring back into the holes, I routed the belt around the pulley and turned it into the groove. This took some time to get it on properly as it is pretty tight. Once the cover was replaced, the washer worked as expected.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

USE WPL 27001233 (Now subbed to Pump)

Part Number: PS1594294

$49.90
In Stock

V-Style Spin and Agitate Belt - 28-3/4 inches long (Now subbed to V-Style Spin and Agitate Belt)

Part Number: PS2027741

$25.29
In Stock