Burner will not heat, display will not light

ApplianceMaytag Range


Level of DifficultyEasy

Time to do repair15 - 30 mins

Age of Appliance5 - 10 years

Tools Nutdriver
Screw drivers

Robert From South Euclid, OH

Mar 17, 2011

12 out of 16 people found this instruction helpful

Two separate problems. The display gradually dimmed over time and finally went out completely. It was really easy installing the new display module. I analyzed the old one and found an 68uF electrolytic capacitor (<$1) that was bad. Don't know if any other component was bad. In looking at the display module it seems it was way over-priced at over $200. The second problem is that one of the small burners had a open heating wire. The installation of the new burner was OK except the new unit did not have any clips to hold it in place. I couldn't transfer the old clips over. So I just placed it under the holding bracket and hoped that it wouldn't move while I was putting the unit back in place and it didn't. So that is working OK now.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Electronic Clock Control Board

Part Number: PS2078472

Recycling Rebate Available
In Stock

Surface Burner Element with Limiter - 6"

Part Number: PS2081079

In Stock