Washer wouldn't fill on hot selection, OK on cold

ApplianceAmana Washer

Model

Level of DifficultyEasy

Time to do repair30 - 60 mins

Age of Appliance1 - 4 years

Tools Nutdriver
Screw drivers

Charles From Vista, CA

Nov 23, 2007

14 out of 14 people found this instruction helpful

Remove the electrical power plug and disconnect the water hoses at the back. Remove the lower front panel by taking out the two screws at the bottom edge. Then lift out the upper front panel which exposes the two sheet metal screws holding down the top panel. Lift open the top panel and secure it up about 90 degrees so it doesn't flop over backwards. Twine tied to something overhead works fine. Replacement procedure for the valve is obvious, once exposed.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

USE WPL R0131578 (Now subbed to Water Inlet Valve Kit)

Part Number: PS2167007

$56.04
In Stock