Repair Story - Wouldn't agitate or spin.
Repair stories from PartSelect's customers - like you. We give all our customers a chance to help out others by sharing the story of their appliance repair. You can find useful tips as well as estimates of the difficulty of the repair and how long it will take, along with any tools you may require to complete your repair.
|
Visitor Rating
|
|
Wouldn't agitate or spin.
|
|
|
Overall Rating:
Very Helpful
Rated By:
15 Customers
Posted By:
Roger From Swainsboro, GA
Posted:
11/15/2007 12:20:31 PM
|
|
|
Appliance Repaired:
|
KitchenAid
Washing Machine
|
|
|
|
|
Age Of Appliance:
|
5 - 10 years
|
First, I removed two screws holding the bottom fiberboard panel in place, and the panel, to gain access to the motor, transmission, and pump. Unfortunately, I had the machine tilted to the front, and didn't have room to release the pump. I had to set the machine back up, and get manuvered around so I could lay it on it's back (I was working in the confines of a small laundry room). Once on it's back, I released the two clips holding the pump with a flat head screwdriver, lifted it up and out of the way without having to disconnect any of the piping, then I released the two clips holding the motor, again with a flathead screwdriver, disconnected the wiring plugs, and capacitor wires, then lifted the motor up and out of the machine. I then removed the two bolts holding the motor mounting plate to the transmission. Then, again using a large flat head screwdriver, I pried the transmission coupling half off the transmission shaft, I had to work it up, while turning the shaft, and then the same for the motor half. I then wiped off both shafts, and gently tapped both coupling halves back onto the shafts,
( this is easier using a socket that is just large enough to go over the shafts). Then I reinstalled the motor mounting plate, slipped the rubber coupling onto the transmission coupling half, lifted the motor into place, and rotated from the pump end to line up with the remaining holes on the rubber coupling. I then reinstalled the clips used to hold the motor in place, reinstallation only took thumb pressure to snap back into place, then, I reinstalled the pump, using the same method, and reconnected the wiring plugs and copacitor leads. Lastly, I reinstalled the fiberboard panel into the bottom, and set the machine upright, slid back into place, and reconnected the hoses and electrical, and tested the machine. Worked perfectly.
In actually took longer to disconnect the machine, and get it out and back in, than it did to replace the coupling.
|
| Parts Used: |
|
| Level of difficulty: |
Really easy |
| Time to do repair: |
15 - 30 mins |
|
|
|
|
|
|
Parts Used in this Repair
 |
|
|
Direct Drive Coupling
|
|
This coupling kit is used between the motor and the transmission on direct drive washers with no belt. This is the newer version and is made with new metal sleeves for added strength.
|
|
|
|
Repair stories are provided by PartSelect customers and are not intended to replace an on-site diagnosis or advice from a qualified appliance service technician. Difficulty of repair and time to repair may vary based on experience.
See the index of all our appliance repair stories.
|
|