Washer always stopped at the 47th and 24th minute of each load and display F1 error code. I would have to press "cancel" and then "start" a few times for it to continue.

ApplianceMaytag Washer


Level of DifficultyReally easy

Time to do repair15 - 30 mins

Age of Appliance1 - 4 years

Tools Pliers
Screw drivers

James From Turnersville, NJ

Jan 20, 2011

107 out of 123 people found this instruction helpful

Removed the dial control top covering by unscrewing the 3 screws in the back of the cover. Once the cover was off, the control module was exposed and all I had to do was:

1. Disconnect the wires that were plugged into the control module

2. Remove the old module. There was 1 screw holding it in place.

3. Replace with the new module. Put back the screw back.

4. Reconnect the wires. There was about a 8 different plugs that needed to reconnected. So I took a few pictures of how the wires were connected/plugged in, with my compact camera (just in case I forgot where each went). I didn't need to use the pictures, but it was just a safety net in case I forgot where each went.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Electronic Machine and Motor Control Board

Part Number: PS2341877

Recycling Rebate Available
In Stock