Rip cloths, buttons being cut off, rust on cloths.

Removed power, gently pried off top with flat screwdriver and undid grounding clip. Put top off to the side.
removed the two philips screw on each top inside of the front panel to side panels. Pried front down and forward, then lifted off front to the side where the wire harness is. Leave the wires alone! On the front, remove the old guide and drum seal, then take a scrubby and the brake cleaner to remove the old glue. Apply the provide glue to the front panel where the guide will go. Note: I think it would be better to slightly rotate the guide in the direction of where the rotation is from. The first two pads were worn off but the third was ok. After the glue is tacky, place the guide on the front panel the same orientation as the one removed. repeat this step for the seal. reassemble in reverse order and you are done. This was the 2nd time I had to do this on the same dryer.