Worm gear stripped.

ApplianceKitchenAid Small Appliance

ModelStandMixer600

Level of DifficultyReally easy

Time to do repair30 - 60 mins

Age of Appliance1 - 4 years

Tools Screw drivers

Stephen From Colorado Springs, CO

Nov 30, 2010

6 out of 8 people found this instruction helpful

Removed mixer motor housing by removing 5 obvious screws.
Removed plastic transmission cover by removing 4 obvious screws.
Down load parts exploded drawing from PartSelect.com
Found the worn part by the shiny teeth on the large gear.
Found the large worm gear on the drawing and ordered the gear, and associated bearings. Did not need the seal.
Removed worn part, assembled new gear and beargings in same manner as the worn part, and placed new part in mixer.
Replaced transmission cover gasket.
Repacked grease from transmission cover onto the new gear.
Replaced transmission cover (4 screws).
Replaced mixer motor housing (4 screws).
Replaced mixer trim band around the motor houseing joing. (1 screw).
Plugged it and and it works, good as new.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Thrust Bearing Kit

Part Number: PS401594

$11.21
In Stock

Worm Gear

Part Number: PS986966

$25.82
In Stock

Transmission Gasket

Part Number: PS1488426

$4.46
In Stock

Front Bearing

Part Number: PS2338652

$3.96
In Stock

Rear Bearing

Part Number: PS2341596

$3.96
In Stock