burner bowl mounting holes out of alignment

ApplianceGeneral Electric Range

Modeljpg336

Level of DifficultyVery Difficult

Time to do repairMore than 2 hours

Age of Appliance5 - 10 years

Tools Screw drivers

Keith From Frisco, TX

Nov 08, 2010

2 out of 3 people found this instruction helpful

No way to adjust mixer tube assembly so the mounting holes will line up with the holes in the burner bowl. Mounting
holes in bowl should be slotted to prevent future problems.
Had to finally bend the mixer tube mounting bracket enough to get one bowl on. It also made the procelin break
on that bowl because the screw put to much pressure on the side of the hole.

Igighter mounting hole out of position just enough to prevent the burner head from sliding over it and sitting on
the mixer tube correctly.

I solved this problem by fileing the opening slot for the igniter. Even with the igniters being just a little out of
alignment from the original position they still light well.

I did not get new gaskets for the burner bowl but would reccommend that you get them.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Large Burner Drip Bowl

Part Number: PS244310

$16.66
In Stock