Dryer would not heat up

ApplianceKenmore Dryer

Model

Level of DifficultyEasy

Time to do repair15 - 30 mins

Age of Appliance1 - 4 years

Tools Pliers
Nutdriver

Clinton From Warren, AR

Oct 20, 2010

5 out of 5 people found this instruction helpful

Un plug or remove power before you start. First you would have to remove the rear panel of the dryer. All you need is a quarter inch nut driver. Then look at the bottom right side of the dryer. There you will see the heating duct. At the very bottom is where the element is. There are two screws on both sides( they will all be removed with a quarter inch nutdriver ). After you have removed the four screws holding the element on you will have to remove two wires from the elemet be sure that you mark them and dont mix them up. You will also have to remove the round temperature sensor because you will have to reinstall it on the new element. Then you get new element and reverse the order of my directions. Good luck and be safe ALL WAYS REMOVE POWER BEFORE WORKING ON ELECTRICAL APPLIANCES.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Heating Element - 240V 5400W

Part Number: PS334313

$62.42
In Stock