Wet dishes at end of cycle

ApplianceKitchenAid Dishwasher


Level of DifficultyA Bit Difficult

Time to do repair15 - 30 mins

Age of Appliance5 - 10 years

Tools Wrench set
Screw drivers

Jason From Clarkesville, GA

Oct 09, 2010

3 out of 3 people found this instruction helpful

After turning off the breaker, disconnecting the water supply, disconnecting the drain line, and taking out the two screws that fasten to the bottom of the counter top, the unit slid right out. Once the unit was out I disconnected the two leads going to the element ends and used a 3/4 ratchet to take the large plastic nuts off. The unit came out very easy and the new one slid right back in. In revers order I had the unit mounted back under the sink in just minutes. I then removed the six torx head screws that allowed the front door unit to come free. The control board was a 4 connector plugs and 1 ribbon cable. No screws on this just move over the plastic tabs and pop the board out. Ran a cycle that night and I'm back in business. Thanks PartSelect.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Heater Element and Electronic Control

Part Number: PS985207

In Stock