Spin cycle would not work leaving clothes wet.

ApplianceMaytag Washer


Level of DifficultyA Bit Difficult

Time to do repair15 - 30 mins

Age of ApplianceMore than 10 years

Tools Nutdriver
Screw drivers

Greg From Charlotte, NC

Sep 01, 2010

2 out of 2 people found this instruction helpful

Replaced the timer.

I set the arrow on the dial to "off"

Hardest part was removing and reinstalling the spring-loaded plastic knob on the dial.

Popped off the central disk, dropped the retaining spring clip with a screw driver and removed the spring assembly and dial from the timer shaft, in sequence. (Repeated this process to install, after new timer was mounted).

Two top screws hold the face plate and two hex nuts hold timer in the mointing.

the timer's lectrical plug and scocket hook up was simple.

I thought calibrating the new timer could be a problem but a permanet pin in the timer shaft points to the cycle (when installed) even when the arrow knob is removed.

Greg Jones, Charlotte N.C.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability


Part Number: PS2017539

In Stock