Right front ignitor switch not operating, possibly got wet when being cleaned.

ApplianceJenn-Air Range

ModelJDR8895AA5

Level of DifficultyEasy

Time to do repair30 - 60 mins

Age of Appliance5 - 10 years

Tools Wrench set
Screw drivers

Lou From Fort Pierce, FL

Jun 29, 2010

20 out of 20 people found this instruction helpful

The truth....This procedure will take 40 minutes total for the average "mechanic".

You will need a #2 phillips screwdriver and two open end wrenches, 1/2" and 5/8"

AFTER unplugging the power cord AND turning
OFF the gas feed:

1-Remove seven phillips head screws from largest rear panel, and remove panel.

2-Disconnect the gas feedline from the manifold with 5/8" open end wrench.

3-Unplug switch "set" ( 2 connectors, one inline and one spade)

4-Open top oven door and remove two hexhead/phillips screws from underside of stovetop, located on far right and far left forward corners.

5-Pull stovetop forward to unlatch from rear holddown clips on frame.

6-Lift stovetop up enough to disconnect five gas burner supply lines from control valves with 1/2" open end wrench.

7-Remove two phillips head manifold attaching screws from topside of control valves (visible after pulling off control valve knobs)...manifold is now free, remove from stove.

8-"Pop off" switches from control valves, and snap new set into place.

9-Install drip shield disks on control valve shafts.

10-Reverse procedure to reassemble stove.

NOTES:
1-Remember to install drip shield disks on control valve shafts before reattaching manifold to stovetop.

2-Check all visible screws for tightness now that the covers are removed, ....you WILL find loose screws...Avoid overtightening/stripping screw holes.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Igniter Switch with Harness

Part Number: PS2004067

$49.13
In Stock