Washer would not always perform final rinse or spin.

ApplianceMaytag Washer

ModelAtlantis

Level of DifficultyEasy

Time to do repairLess than 15 mins

Age of ApplianceMore than 10 years

Tools Nutdriver
Screw drivers

Steven From Arlington, TX

Jun 16, 2010

0 out of 1 people found this instruction helpful

It took a little bit of effort to find the service manual online so I could see how to take apart the console of the washer. I wanted to make sure of how to remove the front knob and timer dial because they can break easily if not done correctly.

I pried off the center cap of the knob, then pulled the center locking post out to release the knob and pointer dial. Then I removed the three phillips head screws on the top of the console housing and pulled the top of the control panel forward while pushing the bottom of the panel towards the rear.

The timer replacement itself was very simple. Remove the wiring harness connector and it is held in by one screw and a locking press tab. Be careful not to hit and break the retaining tabs on the 'AUTO TEMPERATURE' LED socket that mounts right next to the timer.

Reassmble in the reverse order and you are set to go.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Timer

Part Number: PS2021083

$103.06
In Stock