Loud screeching/squeaking when in use

ApplianceGeneral Electric Dryer


Level of DifficultyReally easy

Time to do repair15 - 30 mins

Age of Appliance1 - 4 years

Tools Screw drivers

Michael From Princeton, NJ

May 27, 2010

0 out of 1 people found this instruction helpful

1. Remove Door 2. Remove two screws holding top of dryer on then slide top out. 3. Remove two screws holding front of dryer on. They're towards the top on the inside Then remove front. 4. Drum bearing just snaps out, so just pull or pry it out. And install new one. Just snaps in. 5. Install Drum slides. Make sure you order all four !! . 6. since you have it all apart you should vaccuum any excess debris (lint) out. 7. Put it back together. The top slides in and down , mine needed a "little persuading" back in. Make sure the gasket around the lint tube is still there or lined up properly (mine fell off) . I changed the felt strip also, if you do it make sure you pay attention to how it came off !!
You have to stretch it a little.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Front Dryer Drum Slide (Now subbed to Drum Bearing Slide - White)

Part Number: PS755842

In Stock

Front Drum Bearing (Now subbed to Top Bearing)

Part Number: PS9493079

In Stock

Lower Front Felt Drum Seal (Now subbed to Duct Felt Seal)

Part Number: PS9861764

In Stock