Dryer would run but would not heat.

ApplianceWhirlpool Dryer

Model

Level of DifficultyReally easy

Time to do repairLess than 15 mins

Age of Appliance1 - 4 years

Tools Nutdriver
Screw drivers
Socket set

Danny From Grafton, OH

Apr 23, 2010

0 out of 1 people found this instruction helpful

I took the back panel off with nut driver. I removed the 2 screws that hold the element in place and then marked the wires with a marker and disconnected the wires and removed the element.
Then I reconnected the wires to the new element and put the 2 screws back in holding the element.
Then I cleaned the back of the dryer and the vent to make sure it wasn't stopped up. Then I replaced the back panel with nut driver and replaced the pipe to go outside and turned it on and it works better than it ever has. I have never done this before and was a little nervous about doing it but found out that it was easy.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Heating Element - 240V 5400W

Part Number: PS334313

$64.99
In Stock