dryer would spin, but no heat

ApplianceMaytag Dryer

ModelDE308

Level of DifficultyEasy

Time to do repair15 - 30 mins

Age of Appliance5 - 10 years

Tools Nutdriver
Screw drivers
Wrench(Adjustable)

June From Orinda, CA

Mar 23, 2010

0 out of 1 people found this instruction helpful

First, I removed the two screws holding the front panel in place. These are on the underside of a lip on the front panel - you can't see them unless you get your head down low. Once these screws are removed, the front panel swings up and you can lift it off (you might need to disconnect the door switch). The heater housing has a few obvious mounting screws to remove (and easily removed wiring). There is one mounting screw at the back of the housing, which slightly hard to get to (not hard to remove, bit slightly hard to install). After I replaced the heater housing, the heat only worked for a short time. Next supicious device was the thermostat located on the heater housing. I had to remove the heater housing (again) to get to it. Once I replaced the thermostat, the dryer worked perfectly.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Complete Heater and Housing Assembly - 240V

Part Number: PS2200246

$65.82
In Stock