It was having a hard time starting and would quit.

ApplianceWhirlpool Dryer

Model

Level of DifficultyReally easy

Time to do repair1- 2 hours

Age of Appliance5 - 10 years

Tools Wrench set
Socket set

Christine From Minot, ND

Feb 03, 2010

1 out of 1 people found this instruction helpful

First I had to take the top of the dryer off by taking the two screws off of the lint trap on top then I pushed the top forward a little and lifted up. Then I had to take the front of the dryer off (I think there was two screws). After that I had to take the belt off to be able to get the drum out. I pulled off the old seal and had to use some glue remover to get the old glue off. I then put the new seal on did a little bit at a time to make sure it was on correctly. The glue is really sticky once it starts to dry. It takes two people to put the seal on especially when it gets down to the end. Although my dryer defenitly needed a new seal it was not the problem. It was not very difficult at all, just more time consuming with trying to get the old glue off. Will be buying a new motor, found one cheap and alot less expensive than buying a new dryer considering when I am done I will pretty much have a new dryer for about $120.00.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Rear Drum Seal with Adhesive

Part Number: PS333333

$44.65
In Stock

Multi Rib Belt - 92-1/4"

Part Number: PS346995

$14.08
In Stock